CONTACT US:   Send an Email      (706) 398-1178      (706) 398-1188      1451 Scenic Hwy, Rising Fawn, GA 30738

Vulcan #1 Family Hammer Accessory Guide

Vulcan hammers are designed in “families” of accessory sizing that are designed for maximum adaptability of accessories to a wide variety of hammers. Below is a guide to that interchangeability. While we can verify the compatibility of Vulcan and Raymond accessories, the guide to the Conmaco accessories is just a guide and we cannot accept responsibility for problems arising from the mating of our accessories with their hammers and vice versa.

Accessory Family Vulcan Hammers Raymond Hammers1 Conmaco Hammers3
#1 Type Hammers (11 1/4 or 11 1/2″ Diameter Cushion Pot)

#1, 06, 306, 505, 506, 50C, 65C

#1, 1-S, 50CX, 65C2

50, 65, 50E5, 65E5

#0 Type Hammers (13 3/4″ or 14″ Diameter Cushion Pot, Tapered Cone)

#0,0R, 08, 010, 012, 508, 510, 512, 65CA, 80C, 85C, 100C

2/0, 3/0, 4/0, 5/0 (Keyed Hammers), 80C Modified Vulcan2

80, 100, 125, 80E5, 100E5, 125E5

“95100” Type Hammers (14″ Diameter Cushion Pot, Straight Base Receptacle)

3/0 Cable, 80C Raymond, 80CH

014 Type Hammers

014, 016, 140C

140, 160

020 Onshore Type Hammers (19″ Diameter Pot)

020 and 030 Onshore

020 Offshore Type Hammers (22 1/4″ Diameter Pot)>

020, 030, 530 Offshore; 520, 530 Onshore

200, 300, 200E5, 300E5, 5300

150C Type Hammers

100CX, 125CX, 150C, 30X, 40X, 60X

Notes:

1 All Raymond Hammers were designed to use the Raymond Capblock Shield; these are available from Vulcan. Most Raymond 65CH (and some 65C) hammers used a capblock shield that was integral with the base.

2 Raymond Hammers in this series can always use the Vulcan accessories but Vulcan hammers cannot always use Raymond accessories.

3The guide to the Conmaco accessories is just a guide and we cannot accept responsibility for problems arising from the mating of our accessories with their hammers and vice versa.

©2017 Pile Hammer Equipment
Brought To You By: Absolute Synergy Squad, LLC